A big handy tip for all new users.
Part of your code not doing what you want it to do in run time? Place the END command inside your IF/ENDIFs that seem to be ignored in your running project. ( Or SUBs & FUNCTIONs )
Run your code & if it exits at the given point where your mysterious IF/ENDIF was checked you`ll know its being read but misinterpreted. Go back and look at what youve coded to happen, then step backwards and look at whats leading to it being ignored.
Its also handy to have a pen and pad handy. Pen and paper can save lots of time by scribbling down your plan and formulating that into code later on screen. When it doesnt work - look at what you penned down.
If the search option here fails to help you just ask as there are many here who can help you.
Part of your code not doing what you want it to do in run time? Place the END command inside your IF/ENDIFs that seem to be ignored in your running project. ( Or SUBs & FUNCTIONs )
Run your code & if it exits at the given point where your mysterious IF/ENDIF was checked you`ll know its being read but misinterpreted. Go back and look at what youve coded to happen, then step backwards and look at whats leading to it being ignored.
Its also handy to have a pen and pad handy. Pen and paper can save lots of time by scribbling down your plan and formulating that into code later on screen. When it doesnt work - look at what you penned down.
If the search option here fails to help you just ask as there are many here who can help you.